PowerSDR KE9NS v2.8

for certain situations a roger beep would be helpful for me. for Sat operation with Transverter.
e.g. 200 ms at 2475 Hz (Quindar-Tone)
is there a possibility in powersdr?

I was experimenting with quindar tones. download the latest .190 and check out Setup->keyboard and see what you think.

Darrin
ke9ns

thank you very much Darrin for the great implementation!!!
the start and end sequence, real quindar, that's really great. nice is the Monitor to hear the tone
Is it normal that after releasing the PTT the transmitter stops to transmit and start again immediately and then comes the end tone?

No, you have an early version.
install .191

When you release the PTT the radio stays transmitting until the End tone is done.

Darrin
ke9ns

thank you for the information.
unfortunately the problem still exists .191
I have also made a completely new installation. Flex 3000
When releasing the PTT, the PowerSDR stops/start briefly and then comes the end tone

Philipp

When you unkey the radio, you will see the MOX button will stay RED, MON button will turn RED and the Play button turn GREEN, while it plays the end tone, then all 3 will turn off.
On the 3000 I only tested it with the standard MIC on the front of the radio and my old laptop, but it works just fine.

If you see the STOP/START button flicker there is some other issue related to your database and playing wav files.

go to "Wave" and make a voice keyer VK1 recording and then try to play it (hit the VK1 button on the console), see if anything flickers?

Darrin

I think I have found the problem.
if VAC1 is deactivated it works